The other alternative you have. Is to add a static route yourself on the client side. Add the route manually on the client side in a terminal. sudo route add -net 172.16../24 dev tun0 openvpn has a directive for adding and removing of routes client side in your openvpn config file with with the route option. Adding: route 172.16.. 255.255.255. is my production network. We need to push that route to the VPN settings. So subnet ID for my network is and subnet mask is 16bit which means You`ll enter here data of your production network – network on which computer to which you wish to access reside. Command is. push “route” Save If I google to check my public IP I still use my client/home IP. But only traffic that should resolve to network if routes to the remote network. I kinda figure that my DNS should be using my remote/internal DNS server, but I believe all that is needed is a route to forward any traffic to via VPN tunnel. Please advise. I have two virtual machines both of them in the same internal network (eth1) but only one (the gateway) is actually connected to internet (via eth0) and has openvpn running (on tun0). In the VM-gateway I want to route eth1 through tun0 but I am not able to do it. This is the actual set up: Figure the lines near message Route addition via service succeeded above. Nonetheless, OpenVPN 2.4 has the configuration directive --route-method, which defines whether a Windows client adds routes by using either "IP helper API" or route.exe command. I currently don't know how OpenVPN logs a static route addition using the former method. I have two openvpn clients and a server using shared keys. I have internal routes specified in the ccd directory for both clients, but when they connect, the server only creates the internal route for one of them, despite the logs saying it's creating both. Both clients and the server use the "--script-security 2" command-line option.

Apr 01, 2016 · The Router needs to have a port forwarding for the port you want to use for OpenVPN and forward that port to, which is the IP address of the OpenVPN on the internal network. The next thing you need to do on the router is to add a route for your VPN subnet. In the routing table on your router, add to be sent via 192.168

From the OpenVPN man page:--route network/IP [netmask] [gateway] [metric] This tells the server config to "push" to the client, the route command which sets a networking route of the 10.10.10./24 subnet via the gateway with a metric of 1. Metrics are used to give "preference" if multiple routes exist (such that the lowest cost wins). Configuring your router to run a VPN lets it protect all the devices on your network, but senior security analyst Max Eddy explains why it might not be practical for the average user. In your situation you should try to use standard routing instead of using NAT (between the internal network and the openvpn network). NAT should be your last option. The "edge router" (probably your CPE) (bewteen your internal network and the rest of internet) needs to send the packets for the VPN nodes (in 192.168.3./24) to the Open server. My question: Is it possible to route traffic from the secondary interfaces using either the public IP of eth0 on all machines, or using a VPN connection? I tried connecting one of the first six with one from the new servers using VPN and I had successful connectivity. What I tried so far: Route traffic to the veth network using the tunnel interface

How to configure OpenVPN to access your network. In this OpenVPN connection, the home network can act as a server and the remote device can access the server through the router which acts as an OpenVPN Server gateway. To use the VPN feature, set up OpenVPN Server on your router, then install and run VPN client software on the remote device.

IPv4 Tunnel Network. Choose a subnet that’s not in use in any of the current LANs. This will be used internally by OpenVPN. We’re using here but any private range will do. The /30 mask is because OpenVPN will only use one IP address per site.